Definition of production possibility curves (PPC)

Cambridge IGCSE Economics 0455 – The Basic Economic Problem

1. The Basic Economic Problem

Scarcity is the fundamental economic problem: resources are limited while human wants are unlimited. Because of scarcity we must decide how to allocate resources, which gives rise to three inter‑related questions:

  • What goods and services should be produced?
  • How should they be produced?
  • For whom should they be produced?

In the syllabus these questions are applied to economic goods (goods and services that are scarce and therefore have a price) as opposed to free goods (goods that are abundant and have no price, e.g. air in most circumstances). The distinction between goods (tangible items) and services (intangible activities) is also made, but the PPC model only requires two *outputs* – they can be any combination of goods, services or a mix of both.

2. Factors of Production & Their Rewards

The resources used to answer the three allocation questions are the four factors of production. The syllabus stresses both the quantity (more or fewer units) and the quality (better or worse) of each factor, as well as the mobility of labour.

FactorTypical RewardQuantity vs. Quality Effect on the PPC
Land (natural resources) Rent More or better land → outward shift; less or poorer land → inward shift
Labour (human effort) Wages More workers or higher skill levels → outward shift; fewer workers or lower skill → inward shift
Capital (machinery, equipment) Interest / Profit More or more modern capital → outward shift; less or outdated capital → inward shift
Enterprise (entrepreneurship) Profit More entrepreneurs or better organisation → outward shift; fewer entrepreneurs or poor management → inward shift

Note: The current syllabus retains the concept of labour mobility (workers can move between sectors). Mobility of capital and land is no longer examined, but you may wish to remind students that they are generally less mobile.

3. Opportunity Cost

The opportunity cost of producing more of one good is the amount of the other good that must be given up – exactly the trade‑off shown by the PPC.

Mathematically:

$$OC_{X}= \frac{\Delta Y}{\Delta X}$$

where ΔY is the reduction in output of good Y and ΔX is the increase in output of good X.

Numerical illustration (AO2 requirement):

  • If the economy gives up 4 units of Good Y to produce 2 additional units of Good X, then
    $$OC_{X}= \frac{4}{2}=2\;Y$$ – the opportunity cost of each extra unit of X is 2 units of Y.

Real‑world examples

  • Consumer: Spending £100 on a new laptop means you cannot spend that £100 on a holiday.
  • Firm: Using a factory line to produce more smartphones means fewer tablets can be produced.
  • Government: Allocating more budget to defence reduces the amount available for education.

4. Production Possibility Curve (PPC)

A Production Possibility Curve (PPC) is a diagram that shows the maximum attainable combinations of two goods or services an economy can produce when all resources are fully and efficiently employed, given the existing technology and factor endowments.

4.1 Key Features

  • Trade‑off: Moving from one point to another requires giving up some of the other good.
  • Efficient points (on the curve): All resources are fully utilised.
  • Inefficient points (inside the curve): Some resources are idle or mis‑allocated.
  • Unattainable points (outside the curve): Cannot be produced with current resources/technology.
  • Shape (bowed‑out / concave): Because resources are not equally adaptable to the production of both goods – as more of one good is produced, increasingly larger amounts of the other must be sacrificed (increasing opportunity cost).
  • Limits of the model: Assumes only two outputs, fixed technology in the short‑run, and that all resources are fully employed.

4.2 Diagram (placeholder)

Bowed‑out Production Possibility Curve showing points A (efficient), B (inefficient) and C (unattainable)
Fig 1 – A typical PPC. Axes are labelled “Good X” (horizontal) and “Good Y” (vertical). Points A, B and C illustrate efficient, inefficient and unattainable positions respectively.

5. Movements Along the Curve vs. Shifts of the Curve

  • Movement along the curve: A change in the mix of the two goods produced (e.g., more X, less Y). The economy stays on the frontier, so resources remain fully utilised. The slope at the chosen point shows the opportunity cost.
  • Shift of the curve: The whole PPC moves outward or inward when the economy’s productive capacity changes – more or better resources, improved technology, or changes in trade and the environment.

6. Causes of PPC Shifts

CauseDirection of ShiftExplanation (Syllabus wording)
Increase in quantity or quality of any factor of production Outward More or better resources raise the maximum output of both goods.
Technological improvement Outward More efficient production methods allow more of both goods with the same resources.
Trade (importing a good that can be produced more efficiently abroad) Outward (effective) Specialisation and exchange increase the attainable combinations.
Investment in green / sustainable technology Outward Environment‑friendly innovation can raise productive capacity while preserving resources.
Loss of resources (natural disaster, war, environmental degradation) Inward Fewer or poorer resources reduce the economy’s productive capacity.
Technological regression or ageing equipment Inward Less efficient production lowers the maximum output of both goods.

7. Economic Growth and the PPC

Economic growth is represented by an outward shift of the PPC. It occurs when any of the following happen:

  • Increase in the quantity or quality of factors of production.
  • Technological progress (including sustainable/green technology).
  • Beneficial changes in trade that allow the economy to specialise.

An inward shift signals a contraction of productive capacity, often due to loss of resources or technological decline.

8. Summary of PPC Features

FeatureWhat it Shows
Efficient pointOn the curve – all resources fully utilised.
Inefficient pointInside the curve – some resources idle or mis‑allocated.
Unattainable pointOutside the curve – cannot be produced with current resources/technology.
Shape (bowed‑out)Increasing opportunity cost because resources are not equally adaptable.
Movement along the curveShows the trade‑off and opportunity cost between the two goods.
Shift of the curveReflects changes in resources, technology, trade or environmental sustainability.
Limits of the modelOnly two goods, fixed technology (short‑run), assumes full employment.

9. Why the PPC Matters

  • Illustrates how scarcity forces societies to make choices.
  • Provides a clear visual of opportunity cost for consumers, firms and governments.
  • Shows the concepts of efficiency, under‑utilisation and economic growth.
  • Links changes in resources, technology, trade and environmental sustainability to a nation’s productive capacity.

Create an account or Login to take a Quiz

99 views
0 improvement suggestions

Log in to suggest improvements to this note.